Search

… blade maintenance is crucial to productivity and safe shear operation. An improper blade gap may cause material … 1. Slowly close jaws until the piercing blades are flush with the top edge of the razor blade. 2. Check gap with a … is a quick reference only. It does not replace the product safety and operator’s manuals, which must be followed …

… © 2019 Genesis Attachments, LLC GDT Troubleshooting Guide … is a quick reference only. It does not replace the product safety and operator’s manuals, which must be followed … is a quick reference only. It does not replace the product safety and operator’s manuals, which must be followed …

… Possible Causes/Solutions Does not rotate Blown fuse Test for 24V at plugs on directional valve while depressing … rotate in one direction No electrical power to one side; test for 24V at plugs on directional valve while depressing … reset Power to both rotation solenoids at the same time; test for 24V at plugs on directional valve while depressing …

… slightly depending on excavator mounting location. All Genesis Mechanical Pulverizers are covered by a 12-month, 1,500-hour (whichever occurs first) warranty. Genesis reserves the right to continually … D 4/22 Rev. F 1000 Genesis Drive, Superior, WI 54880 888-SHEAR-IT (743-2748) – Tel: 715.395.5252 – …

… included 1 2 3 4 5 6 © 2022 Genesis Attachments, LLC GMP D_Metric 4/22 Rev. F 1000 Genesis Drive, Superior, WI 54880 … 1,118 826 826 1,016 4/5 36 - 50 Metric Specs: … GMP D Spec Sheet - Metric …

… or square. Jaws must not wear lower than the height of a new blade. Use a new blade to help determine build-up height for the jaw. … build-up is complete, grind material to be flush with a new blade. Note: Closely monitor areas above guide blade bolt …

… ® Attachments protected with Genesis Shear Jaw Armor®, GXT Heavy-Duty Wear Guards and Grapple Jaw Armor not only … Demolition • Scrap Processing • Recycling Shear Jaw Armor® GXT Heavy-Duty Wear Guards APPLICATIONS • Demolition • Scrap …

… to build up, using a straight-edge or square. Do not allow jaws to wear to more than a 3/4 inch radius on edges of tool. … in place of straight stringers on any flat areas of the jaws and on the outside of the upper jaw. Do not crosshatch the curved areas of the jaws near the pivot. Use only straight stringers on these …

… It does not replace the product safety and operator’s manuals, which must be followed by all operators and … to view and download all product safety & operator’s manuals and parts manuals. No log-in required. Using Genesis attachments in …

… is a quick reference only. It does not replace the product safety and operator’s manuals, which must be followed … If the rounded grooves are welded up, use a die grinder with a carbide tool to recut these areas to their original … Minute 1000 Genesis Drive, Superior, WI 54880 888-SHEAR-IT (743-2748)– Tel: 715.395.5252 – …

… is a quick reference only. It does not replace the product safety and operator’s manuals, which must be followed … If the rounded grooves are welded up, use a die grinder with a carbide tool to recut these areas to their original … Minute 1000 Genesis Drive, Superior, WI 54880 888-SHEAR-IT (743-2748) – Tel: 715.395.5252 – …